Table of Contents
Advertisement
Answer: Refer to the TV Guide On Screen section of the owner's manualor follow the on-screen setup
diagram or your TV owner's manual.
11. Q: I've entered the setup data. When will I be able to view my TV program
listings and use other TV Guide On Screen system features?
Answer: After the setup data has been entered, the initial data download for the TV Guide On
Screen system requires your unit to be placed in the Standby mode for the first 24 hours.
. Q: If I incorrectly entered setup data, was unable to complete the initial
12
setup or if I move, how can the settings be changed?
Answer: In any of the above cases you'll need to reset the unit to the factory default settings.
Turn the unit "ON" and allow about 30 seconds for the unit to boot up. Next, if the Channel Guide
screen appears, press the "TV Guide" button on the remote so that you are viewing a TV
broadcast. Simultaneously press the channel UP/DOWN arrow keys on the main unit and hold for
approximately 15 seconds. When the unit is re-powered, the channel lineup and program data will
be deleted and you can start the setup again.
13. Q: If I make a mistake during setup, how do I go back to the previous step?
Answer: There are two possibilities:
1) Press the GUIDE key twice on the remote, then follow the on-screen prompts to re-enter your
information.
2) Complete the remaining setup steps. When "Step 4: Confirming Your Settings" appears,
select "No, repeat setup process." Follow the on-screen prompts and input the correct
information.
1. Q: I've noticed that certain local channels are not displayed in the program
guide, why?
Answer: The actual channels your TV Guide On Screen System displays is determined by
market penetration in your local area. In addition, data for local programming which is not
provided to TV Guide's data distribution network would also not be available.
section "adding local channels" in the xx section.
2. Q: Why do some or all of the channels display "No Listing?"
Answer: There are several possibilities.
For a newly installed unit, the TV Guide On Screen system may have not been given enough
time to download the initial data. This procedure can only occur when the unit is in Standby
mode for a period of 24 hours. The full procedure is explained in the installation section of this
manual. Once the procedure takes place the phrase "No Listings" will be replaced with program
information.
Other conditions that can result in partial or a total loss of program data include:
1)
The channel(s) in question were recently turned ON (in the Channel Editor screen) and TV
Guide On Screen has yet to receive channel data for this channel.
2)
After completing the initial set-up, the first data download of the day was interrupted when
the DVD recorder was turned on.
3)
After completing the initial set-up, the first data download of the day was interrupted by a
scheduled recording. (This only applies to installations using a cable box.)
Channel Lineups and Listings
Please refer to the
16
Advertisement
Table of Contents
