Table of Contents
Advertisement
" Setup
Preparation
Connecting the KX-HGW200 to a Cable/xDSL Modem
14
Before starting to install the KX-HGW200, make sure that you have
everything below and all the devices are turned off.
≥A Windows or Macintosh computer with web browser software*, a network
card (Ethernet, HomePNA or wireless card) and TCP/IP installed.
≥A cable/xDSL modem with a cable
≥An Internet access account and information provided by the ISP
*See "System Requirements" on p. 8 for recommended browsers.
Make sure the cable/xDSL modem is turned off.
1
Connect the category 5 straight cable (with 8-pin RJ-45 connector) to
2
the RJ-45 jack of the cable/xDSL modem.
Connect the other end of the category 5 straight cable to the
3
TO MODEM port of the KX-HGW200.
Category 5
straight cable
To RJ-45 jack
on the Cable/xDSL
modem
TO MODEM port
Advertisement
Table of Contents
