Table of Contents
Advertisement
The Battery
127(
127(
A-4
7KH %DWWHU\
Your cardiograph requires the battery to be installed for proper
operation—even if the cardiograph is plugged into AC power, it cannot
operate without the battery.
Use only the approved battery, part number M2460A, in the
cardiograph.
,QVWDOOLQJ WKH %DWWHU\
To install the battery:
Do not remove the shrinkwrap surrounding the battery.
When you install the battery you may notice a screw hole located near
the battery compartment. This screw hole is the mounting point for the
optional M1705B cart. The mounting thumbscrew is supplied with the
cart.
1. Make sure the cardiograph is unplugged from AC power.
2. Turn the cardiograph bottom-side up.
3. Slide the battery door in the direction of the arrow until it unlatches
(approximately 1/2 inch), as shown in Figure A-2. Lift off the door.
4. Install the new battery in the battery compartment as shown in
Figure A-3 and plug the battery connector into the cardiograph.
5. Place the battery door into its slots and slide the door in the
opposite direction of the arrow until it latches, as shown in Figure
A-2.
6. Turn the cardiograph top-side up.
7. Plug the cardiograph into AC power.
8. Check that the AC indicator light is on. The unit is now in Standby
(off) mode with the battery charging.
Setting up Your Cardiograph for the First Time
Advertisement
Table of Contents
