Table of Contents
Advertisement
(7) ERROR indicator
If a non-recoverable error occurs, this indicator will light. Press the Tr INC and
DISPLAY keys on the controller to determine the kind of error which has oc
curred (explained in "Errors" on page 30).
3.2 Rear panel
The rear panel of the main unit is where audio and control connections are
made.
(p(|)
(3)
ANALOS IN
©HIGH/LOW switch
This switch is used with the analog inputs, to allow the matching of the recorder
input circuitry with the analog source. The two positions correspond to:
Position
HIGH
LOW
Both positions are adjustable ±3dB using the LEVEL ADJ (Lch, Rch) (2).
©LEVEL ADJ (Lch, Rch)
These two trimmer controls allow the fine adjustment of signal levels from the
analog inputs to the recording circuitry. The range is ±3dB from the center po
sition (fully counter-clockwise gives -3dB, fully clockwise gives -i-3dB).
©ANALOG IN
These two XLR-type connectors allow the input of balanced analog signals at
levels determined by the HIGH/LOW switch (1) and LEVEL ADJ (Lch, Rch) (2).
3 • Main unit (YPDR601) - Rear panel
(4) (D® (7)
@
ANALOG OUT
—
I @ to?
Nominal level
+4dBm
-9dBm
Maximum before clipping
+24dBm
+1 IdBm
Main unit (YPDR50D-9
Impedance
lOkQ
50kQ
YPDR
Advertisement
Table of Contents
