Input Select Switches; Toc Switches; Power Switch; Control Connector - Yamaha YPDR601 Operating Manual

4 • Remote controller (RC601) - Rear panel

(5) INPUT SELECT switches

These determine the type of source. The first switch allows selects either analog
or digital input, and the second selects the typ>e of digital source; either AES/EBU
or SDIF-II (D.IN). If the first switch is set to ANALOG, the position of the second
switch has no effect.

(6) TOC switches

These determine the recording mode, as explained in the first section of this
manual ("TOC PRE" on page 3 and "TOC AFTER" on page 3). The first switch
allows the choice of TOC PRE (99 fixed-length tracks) or TOC AFTER (a variable
number of variable-length tracks), and the second switch allows the selection of
either 10 or 30 seconds as the fixed track length when in TOC PRE mode. When
the first switch is set to AFTER, the position of the second switch has no effect.
©POWER switch
This rocker switch controls the power to the controller (independent of the main
unit).

(8) CONTROL connector

Use the supplied 50-conductor cable to connect the controller to the main unit's
I/O IN (15).

(9) AC IN

This is the connector for the AC power cord (supplied)
YPDR
Remote controller (RC601) - 16