Rear Panel; Phones Connector; Phones Level; Drive Select - Yamaha YPDR601 Operating Manual

4.2 Rear panel

(T) PHONES connector
A stereo 1/4" connector for headphone monitoring of the signal selected using
the INPUT/REPRO key on the front panel.
(D PHONES LEVEL
A level control for the headphones connected to the PHONES connector (1).
This control has no effect on the output level from the main unit.
©DRIVE SELECT
When used with a single-recorder configuration, this rotary switch should be set
to "0". When used in a multi-recorder setup, this switch should be set to the
number of recording units being used, minus 1 (eg if three units are being used,
this should be set to "2").

(4) DIP switch bank

The four switches in this bank have the following functions:

EMPHASIS

When this is set ON (up), and an analog source is being used, emphasis will be
added to the signal recorded on the disc. When a digital source is used, this
switch has no effect (emphasis will be recorded depending on the presence or
absence of emphasis in the digital source).

PEAK HOLD

When set to ON, the meters on the front panel will act as peak hold meters (the
highest level will be displayed for a short time before "falling back"") When
OFF, the meters will act as momentary peak meters.

COPY GUARD

This switch enables or disables the writing of the copy-protection flag.

EXT W. SYNC

When using an analog source or an SDIF-II digital source, this selects either ex­
ternal word clock synchronization (ON) or internal word clock synchronization
(OFF). When using a AES/EBU digital source, this switch has no effect, and the
YPDR will synchonize to the source.
4 • Remote controller (RC601) - Rear panel
Remote controller (RC601) - 15
YPDR