Positioner Area; Sd Memory Card Area - Panasonic AV-HS400N Operating Instructions Manual

1. Functions in each area

1-7. Positioner area

N Positioners [X/Y]
This is used to set the PinP position or wipe start position (WIPE and SQ #5) or to select the chroma key area.
It takes effect only when the menu is selected.
The center values of the positioners are set during the time it takes for the unit to start up after its power is
turned on. Do not operate the positioners until after the switcher has started up.
O Rotary encoder [Z]
This is used to set the PinP size or to select the chroma key area. In either case, it takes effect only when the
menu is selected.
Positioner X/Y
Rotary encoder
Z
Switch
Valid menu

1-8. SD memory card area

P SD memory card slot
The SD memory card (sold separately) is inserted
into this slot.
Q SD memory card access LED
This LED lights while the data on the SD memory card is being accessed.
Do not turn off the unit's power or eject the SD memory card while the access LED is lighted. Doing so can
damage the data on the SD memory card.
 Concerning the recommended SD cards
Use of the following SD memory cards made by Panasonic is recommended.
RP-SD18BU1A
RP-SD56BU1A
RP-SDR51U1A
RP-SDR01GU1A
RP-SDM0GU1A


POSITIONER
PinP
Position adjustments
Size adjustments
(size increased by rotating the
encoder clockwise and reduced
by rotating it counterclockwise)
Hold switch down to restore
initial values (X/Y, Z).
All PinP menus
14
Z
Wipe
Start position Selected area position
adjustments adjustments
— Selected area size adjustments
(size increased by rotating the
encoder clockwise and reduced
by rotating it counterclockwise)
Hold switch down to Hold switch down to restore
restore initial values initial values (X/Y, Z).
(X/Y).
WIPE/WIPEPos CHR KEY/Auto
WIPE/SQPos (only when Marker item is set
to On)
 
Chroma key
SD Logo is a trademark.