Toro 02900 Fitting And Operation Instruction Sheet page 6

FITTING INSTRUCTIONS Continued
Fig 3
17. Put these three screws through the three holes in the upper light
mounting position so that the red stop/tail lamp is mounted on
the rear face with the screws pointing through on the front face.
18. Place the M5 plain washer (item 24) and an M5 nyloc nut (item
23) on these three screws.
19. Repeat this procedure for the amber rear direction indicator
(without heat sink) (item 15).
20. Now tighten all fixings including the centre one holding the
rear reflector.
21. Feed all electrical cables down the front of the ROPS frame and
onto the electrical mount panel.
22. The cables must now be connected to the main wiring loom of
the machine and this is done with a connector lead (item 19). It
is important that the following connections are correctly made.
Refer to Fig 3.
23. Fit the 10 and 15 amp fuses as shown. Refer to Fig 4.
24. Drill a 8mm diameter hole on the centre line of the bulkhead,
15mm from the top.
25. Bolt the number plate bracket to the bulk head using items 25,
44, 45 and 46. Tighten the nut enough to allow the bolt to rotate
but not have play.
26. Replace bulk and secure with the two new number plate bolts
and two of the existing bolts.
27. Replace the bulkhead and secure with the 4 bolts. Refer to Fig 2.
28. Fit number plate bracket (item 32) with the mounting bolts for
the bulkhead.
29. Fix the number plate light (item 18) to the mounting
adjacent to the number plate (using items 11, 30 and 31).
30. Feed the cable through the 8mm hole in the bulk head. Push the
connector on the plugs. Refer to Fig 5.
31. As there isn't a number plate light on the right side there won't
be a connector to plug into one of the red/black connectors.
Leave this connector vacant. (Use the blanking plug to cover the
connector. Refer to Fig 3.
Issued: 24.03.11 Approved:
Black
Red
Black
Red
Black
Green
Black
Green
Black
Red
Orange
Fig 4
Fig 5
Mod. No. 5062856.A
Black
Red
BLANK
BLANK
White
Green
White
Brown
Red
10A 15A 10A 10A 10A
Red
Black
Sheet 6 of 12 Part No. 111-5100 (A)
Num. Plate
Indicator
Stop/Tail