Toro 02900 Fitting And Operation Instruction Sheet page 8

FITTING INSTRUCTIONS Continued
47. The cables must now be connected to the main wiring loom of
the machine and this is done with a connector lead (item 42).
It is important that the following connections are correctly
carried out. Refer to Fig 6.
Fig 6
Black
3
White
2
Green
2
Blue
2
1
48. Pass the connector lead through the hole in front of the chassis
towards the cutter manifold and locate the two connectors on the
main wiring loom.
49. Plug the cables into these connectors.
50. Now the switches must be put into the control panel and
connected to the main wiring loom.
51. Remove the six screws fixing the control panel to the control
pod.
52. Carefully lift off the panel ensuring that the connectors to the
existing switches are not disturbed.
53. In the rear face of the control pod, just above the key switch,
are switch blank panels beside the auto limited lift and beacon
switches. Refer to Fig 7.
54. Remove these and push the connectors and wires through the
switch hole. Connect the light and hazard switch before fitting
the switch in the hole.
55. In the control panel, to the right of the horn button there is
another blanking plate. Push this out and insert the direction
indicator switch.
56. Feed the connector lead instrument panel so that the end with the
three connectors are inside the control pod.
57. Connect each connector to the correct switch using the labels as
indicators.
58. Feed the other end of this cable down the control arm and
connect to the multi pin connector on the main loom. This is
located to the right of the transmission pump.
Issued: 24.03.11
4
Approved:
6
Front Marker
Front Indicator
Headlamp
Fig 7
Limited
Lift
Mod. No. 5062856.A
7
8
Black
8 Red / White
7
Black
Green
8
8
Black
Blue
8
8
7
Beacon
Hazard
Lights
Sheet 8 of 12 Part No. 111-5100 (A)