Cps Replacement - Polaris RZR 800 2013 Manual

ELECTRONIC FUEL INJECTION
3. If the resistance is correct.
- Test the main harness circuit between the sensor
connector terminals and the corresponding pin
terminals at the ECU (see wiring diagram).
- Check the sensor mounting, air gap, flywheel ring
gear for damage or runout, and flywheel key. Follow
the "CPS Replacement" procedure to inspect CPS
and flywheel ring gear for damage.
4. If the resistance is incorrect, follow the "CPS
Replacement" procedure.

CPS Replacement

Removal
1. Safely support the rear of the vehicle off the ground
and remove the left-hand rear tire.
WARNING
Serious injury may result if machine tips or falls.
Be sure the vehicle is secure before beginning this
service procedure.
2. If not done already; disconnect the CPS harness
connector (see illustration under "CPS Test").
IMPORTANT: In order to remove the CPS, the rear
portion of the exhaust system and the mounting
bracket between the transmission and rear
gearcase will need to be removed.
3. Remove the exhaust pipe between the elbow pipe
and the exhaust silencer. Remove the exhaust
silencer.
4. Remove the (3) bolts retaining the front portion of the
mounting bracket to the transmission. Retain the
bolts, washers, and spacers for installation.
4.16
5. Remove the bottom bolt that attaches the bracket to
the rear gearcase through the hole in the frame
support as shown.
6. Remove the (2) remaining fasteners that attach the
bracket to the side of the rear gearcase.
7. Remove the bolt from the bracket at the front of the
rear gearcase.
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.