Toro GREENSMASTER 3100 Operator's Manual page 22

4. After you achieve the desired setting, hold the knob
to prevent any rotation and tighten the jam nut.
ADJUSTING LIFT CYLINDERS
When in the raised (transport) position, the front lift
cylinders may be adjusted.
1. Lower the cutting units to the floor.
2. Loosen the jam nut on the clevis of the cutting unit
lift cylinder to be adjusted.
3. Disconnect the cylinder clevis from the lift arm.
4. Rotate the clevis until you achieve the desired
height.
5. Connect the cylinder clevis to the lift arm and tighten
the jam nut.
TRANSPORT OPERATION
Make sure the cutting units are in the highest UP position.
Set the shift selector in No. 2 if conditions will permit
faster ground speed. In rough or hilly areas, shift to No. 1
and operate at slower ground speeds. Use the brakes to
slow the machine while going down steep hills to avoid
loss of control. Always approach rough areas at a
reduced speed (shift selector in No. 1), and cross severe
undulations carefully. Familiarize yourself with the width
of the machine. Do not attempt to pass between objects
that are close together so that you can prevent costly dam-
age and down time.
INSPECTION AND CLEAN-UP
AFTER MOWING
After mowing, thoroughly wash the machine. Use a gar-
den hose without a nozzle so excessive water pressure
doesn't contaminate and damage seals and bearings.
After cleaning, inspect the machine for possible hydraulic
fluid leaks, damage or wear to the hydraulic and mechani-
cal components. Also check the cutting units for sharp-
ness. Lubricate the mow and lift pedal and the brake
shaft assembly with SAE 30 oil or spray lubricant to deter
corrosion and keep the machine performing well during
the next mowing operation.
22