Features; Precautions For Use - Panasonic AK-HRP250G Operating Instructions Manual

Features

This unit is a remote operation panel for controlling a studio handy camera (AK-HC3900/AK-UC3300) and a camera control unit
(AK-HCU250/AK-UCU600).
Scene files, user files, and lens files can be saved to a memory card.
The unit can be connected to one CCU (AK-HCU250/AK-UCU600) via a serial connection.
Eliminate the need for individual ROP cables by connecting up to 19 CCUs via a network hub (100base-TX switching hub).
The unit is equipped with PoE*
2
pliant)* .
ROP Setup Software can be used to set the camera connections and unit.
*1: Power over Ethernet. Referred to as "PoE" in this manual.
*2: For details on PoE power supply devices for which operation has been verified, consult your dealer or Panasonic representative.

Precautions for Use

In addition to the safety precautions given in "Read this first!", also observe the following instructions.
Handle carefully
Do not drop the unit or expose it to strong impacts or vibrations. Do not carry the unit by the [IRIS] lever. Doing so may cause a fail-
ure or accident.
Use the product in an ambient temperature of 0 °C to 40 °C (32 °F to 104 °F)
Exposure to temperatures below 0 °C (32 °F) or above 40 °C (104 °F) could adversely affect Internal components.
Power off before connecting or disconnecting cables
Connect and disconnect cables when the unit is turned off.
Avoid humidity and dust
Avoid using the product in a very humid or dusty place because a lot of humidity and dust will cause damage to the internal com-
ponents.
Cleaning
Turn the power off and wipe the product with a dry cloth.
To remove stubborn dirt, dip a cloth into a diluted solution of kitchen detergent (neutral detergent), wring it out well, and wipe the
product gently. Then, wipe the product with a cloth dampened with water. Finally, wipe the product with a dry cloth.
NOTE
Avoid using benzine, paint thinners and other volatile fluids.
If a chemical cleaning cloth is to be used, carefully read through the precautions for its use.
Avoid open flames
Do not place candles and other sources open flame near the unit.
Avoid exposure to water
Make sure that the unit is not directly exposed to water. Exposure to water could damage it.
Disposal of the unit
When the unit has reached the end of its service life and is to be disposed of, ask a qualified contractor to dispose of the unit prop-
erly in order to protect the environment.
1
, allowing connection to a network device that supports the PoE standard (IEEE802.3af com-
- 18 -
Introduction