HP MSR2000 Series Manual page 29

IMPORTANT:
 To install a MIM, install it to the HMIM adapter and then insert it into the HMIM slot.
You can install a MIM when the router is powered on. However, before replacing a MIM when the router

is powered on, you must execute the remove hmimslot
A MIM interface module can be 1U or 0.5U. This section takes a 0.5U interface module for example.

When you install a 1U interface module to an MSR router, remove the filler panels of the target slot and
the neighboring slot above, and use the 1U HMIM adapter.
 If you install MIMs on both of the HMIM slots on an MSR3024, when you insert a MIM to the upper slot,
slightly press down the MIM, and then push it into the slot.
To install a MIM:
Remove the fastening screws with a Phillips screwdriver to remove the filler panel.
1.
Push the MIM slowly along the slide rails until it makes close contact with the backplane of the
2.
HMIM adapter.
Fasten the fastening screws.
3.
Fasten the captive screws on the MIM to secure it to the HMIM adapter.
4.
Figure 29 Attaching a MIM to an HMIM adapter
Push the MIM into the slot along the slide rails until it makes close contact with the backplane of the
5.
router.
Fasten the captive screws to secure the MIM to the router.
6.
Figure 30 Installing the MIM to the router
slotnumber
xviii
command.