Toshiba MCY-MAP0367HS-UL Owner's Manual page 16

 4-way Cassette type
REQUIREMENT
Clean the heat exchanger with pressurized water.
If a commercially available detergent (strong alkaline or
acid) cleaning agent is used, the surface treatment of the
heat exchanger will be damaged, which may degrade
the self cleaning performance.
For further details, contact the dealer.
Replacing antibacterial glass
Have your dealer replace the antibacterial glass every
10000 hours of the cooling operation.
Antibacterial glass
Part code 43179152
Cleaning the air filter
If appears on the remote control, clean the air filter.
1
Open the air intake by sliding the latches.
Let the grille drop while holding it.
Air intake
Knob
29-EN
2
Remove the air filter from grille.
Strap to
prevent falling
Air filter
3
Vacuum the filter and rinse it with water.
4
Dry the filter.
5
Wipe the inside of the air intake with water or
mild detergent and then dry it.
6
Reinstall the filter.
7
Close the grille and secure it to the frame by
the latches.
Air intake
Knob
8
Push button to reset filter timer.
"FILTER " disappears.
CAUTION
Do not start the air conditioner while leaving the panel
and air filter removed.
– 15 –
Cleaning Unit Grille and Frame
To clean the grille and the frame, wipe the outside with
a soft, dry cloth. If necessary, a mild liquid detergent
can be applied and wiped off with a dry cloth.
Cleaning The Louvers
1
Remove the discharge louver by holding it at
both ends and pulling downwards towards
the center.
2
Clean the louvers with water or mild
detergent.
3
Mount the discharge louver by inserting one
end and bending it outwards to allow the
other end to be inserted.
2)Insert in the louver sagging
down the center downward.
1) Insert
NOTE
Install the louvers with the marking faces upwards.
Preparing for long Shut Down Period
1
Clean the filters and reposition them in the
unit.
2
Operate the unit in the fan mode for 3 or 4
hours to dry all the internal parts.
3
Turn the unit off and disconnect the main
power supply.
4
Before the unit is turned on again, ensure
the circuit breaker has been turned on for at
least 12 hours.
 Ceiling type
Cleaning the air filter
If appears on the remote control, clean the air filter.
1
Open the air intake by sliding the latches.
Let the grille drop while holding it.
Air intake latch
2
Remove the air filter from the grille.
Hook
Air filter
Handle
Hook
Handle
3
Vacuum the filter and rinse it with water.
4
Dry the filter.
5
Wipe the inside of the air intake with water or
mild detergent and then dry it.
6
Reinstall the filter.
7
Close the grille and secure it to the frame by
the latches.
Latch
Air intake
Air filter
8
Push button to reset the filter timer.
"FILTER " disappears.
30-EN