78K0 - Shine It!
5.
Select the lnk78f8024_EV-K0-HCD.xcl linker command file. This file can be found in the
IAR Embedded Workbench folder C:\Program Files\IAR Systems\Embedded Workbench
Kickstart 5.0\78k\config
Note: If you have changed the install location of the IAR Embedded Workbench during
installation please refer to the selected location "IAR installation folder"\78K\config
7.
Start a Debug session. Project → Debug Now you should be connected to the target
device using the IAR C-SPY debugger.
Note: Make sure to set back the original debug communication DLL from the backup file
after finishing the debug session.
Figure 57: IAR Embedded Workbench Linker Options
Figure 58: IAR Embedded Workbench .xcl file selection
User's Manual U19610EE3V0UM00
50