Installation Location - Pioneer CP-VSL3 Installation And Usage Instructions

This unit is not provided with screws
necessary for wall mounting. Please
provide the appropriate screws based on
the material and strength of the wall
where the unit is to be mounted.
This unit is designed for exclusive use with Pioneer Speaker
System S-VSL3.
Do not use with any speaker system other than
the one for which the unit was designed. Do not
attempt to modify the structure or use for other
PROHIBITED
than the unit's designed purposes.
Improper or unsafe mounting may allow
speakers to fall, leading to dangerous accidents.
CAUTION

Installation Location

The location selected for mounting should be
flat, and strong enough to fully able to support
CAUTION
the weight of fixture and speaker.
Depending on the kind of wall construction,
some types of walls may not be strong enough to
safely support the unit and speaker; consult a
professional installation technician for advice.
When using other kinds of installation, be sure to
read the speaker system S-VSL3's Operating
Instructions fully and abide by all instructions there.
Never install the unit at a slanting angle,
horizontally, or upside down. Also, never attach
PROHIBITED
the unit to a ceiling.
Do not install in locations where people may
easily hang from or lean against the unit.
Do not install outdoors, in hot spring baths, or in
locations near the ocean.
Do not install in locations where the unit may be
exposed to vibration or impact.
Assembly and Installation
Follow the designated assembly steps properly,
and fasten the assembly screws securely in the
designated locations. Failure to follow these
CAUTION
assembly instructions correctly may cause
damage to the unit or lead to dangerous
accidents after installation.
If you discover any abnormalities or irregularities
during assembly or installation, contact your
professional installation technician for repairs
as soon as possible.
Due to varying environmental conditions, this
fixture may be subject to aging and lose adequate
supporting strength after an extended period of
usage. We highly recommend that each five years
of use (on average), you consult your professional
installation technician and have the fixture
inspected to assure continuing safety.
6
En
Confirm Parts
Please confirm that all parts are present before assembling.
Note
• Screws required for wall installations are not furnished and
must be provided by the user.
• A Phillips screwdriver is required for assembly.
• Wall plates (body) x2
• Upper plates x2
<SNA1422>
• Safety strap x2
<SEW1031>
• Bushings x4
<SEP1303>
• Allen (hex)
wrench #5
<SEX1024>
(for base)
• Installation and Usage Instructions <SRD1265>
Numbers in angle brackets <> are parts serial numbers.
• Terminal cover x2
<SNN1020>
• Screws x6
<PMM60P120S>
• Allen (hex)
wrench #3
<SEX1023>
(for upper part)