Assembly And Installation - Pioneer CP-VSL3 Installation And Usage Instructions

Assembly and Installation

1
Remove base
Using the provided Allen wrench, remove the three base
screws and then the base from the speaker. Save these
screws and the base if there is any chance you will want to
replace the bases for ordinary floor installations in the
future.
2
Attach upper plate
Using the furnished 3 mm Allen wrench, remove the four
screws from the top of the speaker. Place the upper plate
on the speaker top and use the 3 mm Allen wrench to
tighten the removed mounting screws.
Since the hex holes in the mounting screws are rather
shallow, be sure to hold the Allen wrench securely to
prevent slipping, and tighten the screws securely to
prevent slipping.
3
Fasten the safety strap to the speaker
Temporarily remove the mounting fixture on the rear of the
speaker, place around the safety strap and once again
fasten the mounting fixture to the speaker.
Safety strap
4
Temporary mounting
When the mounting fixture is combined with the
speaker system S-VSL3, the total weight is about
10 kg. The installation technician should decide
NOTE
on the optimum mounting method based on an
assessment of the wall's materials and
structure.
• Confirm the height from the floor. Enough space
must be left between the floor surface and the
speaker body to allow the introduction of a
screwdriver in order to install and tighten the
terminal cover.
Hole for temporary
mounting (φ 5.5)
Consult the dimensional
diagram on P. 9 for
external dimensions
following speaker
installation.
5
Mark the position of the mounting screws
Use a level or plumb bob to confirm the perpendicular,
and mark the position of the mounting screws on the wall.
The mounting screws should have a diameter of 4-5 mm (5
mm is recommended) in 6-8 locations. The safety strap
location and mounting screw diameters should be 1
screw of 5-6 mm in the upper square hole (6 mm is
recommended); bushing location and screw diameters
are 2 screws of 5-6 mm (6 mm recommended) within the
9x15 rectangular hole.
70
85
Floor
7
En