Huawei BTS3900 GSM Commissioning Manual page 80

9 Commissioning the BTS3900 Services
Prerequisite
l
l
l
l
l
Procedure
Step 1 Connect the MS to the USB port of the computer using a USB cable.
Step 2 Activate the GPRS or EGPRS data services using the MS. Then, test PS services through multi-
service testing, such as multimedia message sending, website browsing, and file downloading.
Step 3 Check whether the multimedia message sending, website browsing, and file downloading are
successful.
If...
The testing of one type of PS services is
successful,
The testing of three types of PS services
fails,
Step 4 Repeat
by the BTS.
----End
9-6
One test MS, which supports GSM and is registered with the HLR, is available. This MS
is GPRS-capable.
The BTS is configured with the GPRS or EGPRS services.
The logical cell to be tested is activated.
The computer and BSC are operating normally.
The signaling channel loopback test and traffic channel loopback test are conducted. The
test results are normal.
Step 1 through Step 3
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
Then...
You can infer that the BTS hardware meets the
requirements of PS services.
Check whether the test MS is faulty. For
example, the test MS does not have a SIM card,
or the SIM card does not support authentication
and encryption.
to commission PS services in all the other logical cells covered
BTS3900 GSM
Commissioning Guide
Issue 03 (2008-07-15)