Table of Contents
Advertisement
Starting Projection
Connect the power cord and turn on the projector to start the projection.
Once the projector is turned off, it cannot be turned on for a while. Wait until the lamp is
cooled down and the [POWER] indicator lights in red.
1
Connect the power cord.
Fully insert the power cord plug into the socket.
The [POWER] indicator flashes red.
2
Press the [POWER] button.
The [POWER] indicator flushes green, and
then lights in green.
The countdown window is displayed for
approximately 20 seconds, and then the
guiding message for the auto setup function
appears.
The LED illumination lamp blinks blue until the projection is started.
To project an image immediately, press the [OK] button.
Enter a password if the Password input screen appears (P101, 102).
You can turn on the projector by connecting the power cord without pressing the [POWER]
button (direct power on) (P97).
You can display a specified Logo on the countdown screen (P88).
You can specify whether to enable or disable the LED illumination lamp (P100).
You can skip the countdown window (P88).
35
Advertisement
Table of Contents
