Canon X600 User Manual page 61

3
Press the [AUTO SET] button again.
One or more functions highlighted in black are performed automatically.
You can perform this step by selecting [OK] with the [<] button, and then pressing the
[OK] button.
Selecting an Input Signal
Select [DIGITAL VIDEO] among the following 4 input signals by following the steps shown
in the "Selecting DIGITAL VIDEO" section below if you want to project a digital content
video image.
DIGITAL VIDEO : Digital signal
COMPONENT : Component signal Connecting with a supplied component cable
SCART : SCART signal
VIDEO : Video signal
S-VIDEO : S-VIDEO
The component, video, and S-VIDEO signals are automatically set if a cable is connected
and the input signal is confirmed.
A LED (green) on a terminal flashes when an input signal is confirmed. The LED turns on if
the signal is selected and projected.
Connecting with a HDMI/DVI cable, the image may be projected with the minimum resolu-
tion (480p or 575p) due to the specification of the AV equipment.
Selecting DIGITAL VIDEO
1
Press the [INPUT] button.
The [INPUT] window appears.
Connecting with an HDMI/DVI cable or DVI digital
cable
Connecting with a supplied SCART cable
Connecting with a video cable
Connecting with an S-Video cable
61