Sealey VS4656 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. SAFETY
WARNING! Wear approved eye protection. Wear appropriate Personal Protective Equipment. A full range of Personal Protective
R
Equipment is available from your Sealey dealer.
WARNING! Ensure that Health & Safety, Local Authority Regulations and general workshop practice Regulations are adhered to when
R
using tools.
DO NOT use tools if damaged.

Maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.

Ensure that a vehicle that has been raised by a jack is adequately supported. Use axle stands.

DO NOT attempt to start or move a vehicle whilst in gear and with timing devices fitted.

Wear suitable clothing to avoid snagging. DO NOT wear jewellery. Tie back long hair.

Account for all tools, parts and components being used. DO NOT leave these in or near the engine. Return tools to suitable storage

after use.
When not in use, store in a safe, dry childproof place.

Keep children and unauthorised persons away from the work area.

IMPORTANT! These instructions are provided as a guide only. Always refer to the vehicle manufacturer's service instructions
V
or a proprietary manual to establish the correct procedure and data.
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations. The Operator /
R
user must apply caution and common sense (good practical sense).
When timing an engine, always prevent the engine from being turned over. Use a notice and / or inhibit the engine.

WARNING! Incorrect or out of phase camshaft timing can result in contact between the valve head and the piston crown. This will
R
cause damage to the engine.
2. INTRODUCTION
Kit provides the special tools required when replacing the timing belts on Honda engines. Includes tensioner tools and locking pins.
© Jack Sealey Limited
INSTRUCTIONS FOR
PETROL ENGINE SETTING/LOCKING SET -
HONDA 1.6, 1.8, 2.0, 2.2, 3.0 S.O.H.C/TWIN CAMS
- BELT DRIVE
VS4656
MODEL NO:
Original Language Version VS4656 | Issue 4(SP) 16/06/16