Shroud Installation (continued)
Quick Shoot Controls Replacement
Quick Shoot Controls Removal
Chassis: Service and Repairs
g320929
6. Install the chute and chute handle to the chute seal ring. Install the 3 (1/4-10
x 2 inch) plastite screws securing the chute handle and chute to chute seal
ring. Torque the screws to 2.8–4 N • m (25–35 in-lb).
Note: QZE models have a 1/4–10 x 1.5 inch plastite screw.
Note: Some models will have a chute handle attached to the chute.
g321389
1. Park the machine on a level surface. Stop the engine, wait for all moving
parts to stop and remove the key.
2. Remove the shroud from the machine.
3. Remove the (1/4-20 x 2.25 inch) screw and lock nut securing the chute ring
retainer and quick chute gear assembly to the chute support ring. Remove
the quick chute gear assembly from the machine.
Figure 50
Figure 51
Shroud Removal (page 5–8)
Page 5–12
POWER CLEAR® 721/821 Snowthrower Service Manual
3438-776 Rev A