Mechanical Mounting; Pneumatic Connection; Electrical Connection - ABB TZID-C Operating Instructions Manual

0 Brief operating instructions
Read and observe the safety instructions in chapter 1 of these operating
instructions.
Caution

Mechanical mounting

see fold-out drawing

Pneumatic connection

• Connect the air supply to the in port. Air supply range must be between 1.4 and 6 bar
(20 to 90 psi).
Caution: Do not exceed the max. pressure of the actuator!
• Connect the actuator supply to the OUT1 port (and OUT2 port for double acting actuators).

Electrical connection

• Make the electrical connections according to the following terminal designation:
+11/-12 Analog input, 4...20 mA signal
+31/-32 Analog output, position feedback, 4...20 mA signal*
+41/-42 Digital position feedback, SW1 *
+51/-52 Digital position feedback, SW2 *
+81/-82 Digital input
+83/-84 Digital output, alarm contact
+41/-42 Kit for digital position feedback, Limit 2*
+51/-52 Kit for digital position feedback, Limit 1*
+41/-42 Shutdown module*
41 Kit for digital position feedback, 24 V microswitch, Limit 1, NC contact *
42 Kit for digital position feedback, 24 V microswitch, Limit 1, NO contact*
43 Kit for digital position feedback, 24 V microswitch, Limit 1, input*
51 Kit for digital position feedback, 24 V microswitch, Limit 2, NC contact*
52 Kit for digital position feedback, 24 V microswitch, Limit 2, NO contact*
53 Kit for digital position feedback, 24 V microswitch, Limit 2, input*
* Option
a Brief operating instructions
Brief operating instructions
42/18-64-4 EN