Hitachi C 15FB Instruction Manual And Safety Instructions page 13

5. Stopper for precision cutting (Standard accessory)
Fig. 10
6. Handle position adjustment
Upper Limit
10mm Depth
Adjustment Bolt
Fig. 11
7. Using an ink line
Fig. 12
WARNING:
Never operate the lever while the saw blade is rotating.
The stopper facilitates continuous precision cutting in lengths of
11 - 5/8" to 18 - 1/2" (295 mm to 470 mm).
To install the stopper, attach it to the holder with the 6 mm wing
bolt as shown in Fig. 10.
Holder
Stopper
6 mm Wing Bolt
During cutting operation, adjusting the upper limit 10mm depth
adjustment bolt according to workpiece height as illustrated in Fig.
11, reduces the up - down handle movement range for a higher
operating efficiency.
Loosen the 10 mm lock nut which fixes the upper limit 10mm depth
adjustment bolt and move the handle up and down to allow the
10mm depth adjustment bolt to be set in a position suitable for the
height of the workpiece to be cut. Then tighten the 10 mm lock nut.
For cutting along a pre - marked line on the workpiece, lift the safety
cover by operating the lever as shown in Fig. 12, and align the saw
blade with the pre - marked line, before starting cutting operation.
Lever
English
13