Electromagnetic Compatibility; Interference Immunity - Siemens SIMOTICS XP Operating Instructions Manual

Safety information

2.8 Electromagnetic compatibility

The ESD protective measures required for components that can be destroyed due to
electrostatic discharge are shown in the following drawings:
a = conductive floor
surface
d = ESD overall
Risk of explosion due to electrostatic discharge
Electrostatic discharge poses a potential ignition source. Dangerous electrostatic charges can
occur, for example as a result of mechanical friction, flowing air that contains particles - or
persons that are not appropriately grounded, e.g. when carrying out maintenance or cleaning
work.
In an explosive atmosphere, there is a risk of an explosion. This can result in death, serious
injury or material damage.
• Avoid carrying out work specified above on non-metallic parts, e.g. foam rubber for noise
dampeners/attenuators.
• Please comply with ESD protective measures.
2.8 Electromagnetic compatibility
Electromagnetic compatibility
This machine is designed in accordance with IEC/EN 60034, and when used as specified, it
complies with the requirements of European Directive 2014/30/EU regarding Electromagnetic
Compatibility.
2.9

Interference immunity

By selecting suitable signal cables and evaluation units, ensure that the interference
immunity of the machine is not diminished.
16
b = ESD table
e = ESD wristband
c = ESD shoes
f = cabinet ground connection
1MB..5/6 shaft height 71 ... 355
Operating Instructions, 10/2021, A5E41926185A