Advertisement
Quick Links
Mud Pump Transducer Relocation Kit
DD4045 Directional Drill
Model No. 137-5226
This product contains a chemical or chemicals known to the State of California
Preparing the Machine
1. Move the machine to a level surface.
2. Shut off the engine and remove the key.
3. Set the battery-disconnect switch to the
Installing the Kit
Loose Parts
5x
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
to cause cancer, birth defects, or reproductive harm.
OFF
1x
Register at www.Toro.com.
WARNING
CALIFORNIA
position.
1x
1x
Form No. 3415-957 Rev A
Installation Instructions
Original Instructions (EN)
All Rights Reserved *3415-957* A
Printed in the USA
1x
Advertisement
Related Manuals for Toro 137-5226
Summary of Contents for Toro 137-5226
- Page 1 Form No. 3415-957 Rev A Mud Pump Transducer Relocation Kit DD4045 Directional Drill Model No. 137-5226 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Disconnecting the Transducer g212364 Figure 1 1. Locate the transducer below the bulkhead, just above the fuel-tank sending unit (Figure 2. Disconnect the wire harness from the transducer fitting (Box A of Figure 3. Remove and save the transducer assembly and fitting currently installed (Box A of Figure 4.
- Page 3 Installing the Transducer g215620 Figure 3 1. Remove the hose from the fitting on the rear control weldment (Box A of Figure g215621 Figure 4 2. Remove and save the fitting from the rear control weldment (Box B of Figure 3.
- Page 4 8. Torque the transducer adapter to 79 to 98 N∙m (58 to 72 ft-lb) and the transducer to 46 to 57 N∙m (34 to 42 ft-lb). 9. Route the harness along the existing harnesses over to the transducer (Figure Important: Do not route the wire harness near moving parts.