Advertisement
Using the internal fax/modem
You can use the internal fax/modem to perform fax and data trans-
mission (9.6 kbps for fax and 33.6 kbps for data).
Connect the internal fax/modem to an analog telephone line as fol-
lows:
1. Use a finger to gently open the modem port.
2. Insert one end of the supplied modular phone cable into the mo-
dem jack.
3. Insert the other end of the modular phone cable into a telephone
outlet.
Note:
Before using the internal fax/modem for communication, check that it
is set up in Windows CE.
Using a PC Card
Caution:
Not all PC Cards will work with the unit. Be sure to use only recom-
mended PC Cards. Using non-recommended PC Cards may cause
problems such as damage to the unit or the PC Card.
Contact your local dealer for more information on recommended PC
Cards.
Inserting a PC Card
Insert the PC Card into the slot as far as it will go. Make sure the PC
Card is facing up. If the card will not go in, check the orientation.
Never force the card or it or the main unit may be damaged.
Removing a PC Card
1. Close all applications accessing, or otherwise utilizing, data on the
inserted PC Card.
2. Turn off the unit.
3. Slide the eject switch to release the PC Card, and remove it by
hand.
4. Data Exchange with other devices via IP
Data exchange with other devices via IR
You can exchange data with other devices such as SHARP ZR Se-
ries units, using infrared communication. The following tables indicate
the type of data you can exchange.
Your unit
ZR Series unit
Contacts
Contact1
Explorer
PC Files
Your unit
IrTran-P device
Image Editor
(depends on the device)
Note:
You must install the software program from SHARP CD-ROM before
exchanging data with the IrTran-P device.
– 38 –
How much data
One or more contacts
One file
How much data
One JPEG file
Advertisement
