Table of Contents
Advertisement
8.5.
Remove the Tuner unit
1. Unlock the cable clampers to free the cable.
2. Disconnect the connectors (A1, A3, A5, A6, A7, A8, A11
and A12).
3. Remove the screws (×2
Tuner unit.
, ×1
) and remove the
8.6.
Remove the A-Board
1. Remove the Tuner unit. (See section 8.5.)
2. Remove two EDGE SADDLES at top of case.
Twist the EDGE SADDLE to press up at the back and pull
down the front side.
3. Remove the screws (×4
Caution :
Press up the case not to touch the leg of clamper to the A-
board.
Pay attention two metal projection
removal and assemble.
21
) and remove the A-Board.
from back side when
Advertisement
Table of Contents
