Example Project For Central I/O Expansion; Preconditions; Create, Set-Up And Save Your Ac500 V3 Project - ABB AC500 Installation And Configuration Manual

Hide thumbs Also See for AC500:

Table of Contents

Getting started with AC500 V3 products

Example project for central I/O expansion > Create, set-up and save your AC500 V3 project

1.4 Example project for central I/O expansion

The following steps show how to set-up an application project and configure the hardware. A

simple logic is used as example to introduce in programming and commissioning of the PLC.

The workflow for creation of a visualization is explained, as well as how to set-up a webserver

for visualization.

●

Automation Builder is installed and licensed as, at least, basic edition

neering software Automation Builder" on page 3.

●

AC500 V3 CPU is assembled and connected to the PC.

1.4.2.1

Create a project

Plug the appropriate electronic and I/O modules in the correct locations (processor

module, communication modules on terminal base, and eventually also communication

interface modules and I/O modules onto dedicated terminal units).

Connect a programming cable (Ethernet cable between ETH port of CPU and PC with

engineering software).

Launch Automation Builder either out of the desktop icon or out of the Windows menu.

Select "New Project" or go to menu "File è New Project".

3ADR010584, 2, en_US

Ä Chapter 1.2 "Engi-

2021/05/14

Table of Contents