Advertisement
empty the water tank and the appliance
will stop immediately. See section "5.12
Use the Water Tank" to know how to
handle and empty the water tank.
NOTE:
• In SLEEP mode, no beep sound
reminder when the Water Tank is full.
5.11 Alerts & Errors
When a problem occurs in the appliance,
the "
" indicator will show on the control
panel and the display will show the
corresponding error code at the same time.
E4- DC Motor failure
E5- Humidity sensor failure
E6- Communication Failure
E7- Indoor defrost thermistor failure.
E8- Refrigerant Leakage
NOTE:
• When error code occurred, the appliance
will stop operation completely.
• When error code occurred, unplug the
unit and plug it back in. If error repeats,
please contact Authorised Service
Centre.
5.12 Removing collected water
There are two ways to remove collected
water.
Use the Water Tank
When the water tank is full, the Water Tank
Full indicator "
" will flash and the unit will
make a double short beeps and repeat the
sounds after first double beeps to remind
you to empty the water tank.
Following the steps below to remove the
collected water from the water tank:
1. Grip the water tank edges of the
grooves on both sides securely, then
pull out the water tank a little.
2. Hold both sides of the water tank with
even strength, and pull it out from the unit.
3. Grip the water tank handle and open the
water tank sealing cap in the side
corner, then empty the water tank.
ENGLISH
11
Advertisement
