Advertisement
12 www.electrolux.com
4. Close the sealing cap and put back the
water tank in place.
The water tank full indicator will turn off,
and the unit will start up again when the
water tank is restored in its correct
position.
NOTE:
• When you remove the water tank, do
not touch any parts inside the unit,
otherwise the product may be
damaged.
• Be sure to push the water tank gently all
the way into the unit. Banging the water
tank against anything or failing to push it
in place may cause the unit not to
operate.
• Because the castors cannot be locked,
you need to apply a limited force so that
appliance does not move suddenly.
• Discard water from water tank. The
water in the water tank is not potable.
Continuous Drainage
Once the continuous drainage is enabled,
water can be automatically emptied from
the appliance and the water will not flow
into the water tank unless there is
something wrong with the continuous
drainage. You will need a drainage hose
and a drain nearby to discharge the water
into before conducting this operation.
Following the steps below to make sure
the hose to be connected correctly:
1. Pull down the drainage plug at the back
of the unit.
2. Push the drainage hose firmly into the
drainage outlet to make sure the hose
to be connected to the unit properly so
there will be no leaks.
3. Direct the hose toward the drain and
place the other end of the hose into the
drain, making sure that there are no
kinks that will stop the water from
flowing smoothly.
4. Select the desired humidity setting and
fan speed on the unit for continuous
draining to start.
NOTE:
• Make sure the water tank has been
installed properly before trying to
connect the drainage hose to the
drainage outlet.
• Shake or pull the hose slightly to make
sure the hose is connected properly. If
there is a leak, pull out the hose and
repeat the above-mentioned hose
connection process.
• It is recommended that a Dehumidifier
Drain Hose - (12 mm) be used. Make
sure there are no kinks or elevations in
the hose.
Advertisement
