Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1
Installing the Auxiliary
Handle
Parts needed for this procedure:
1
Auxiliary handle
1
Latch
1
Brace
1.
Position the auxiliary handle on the shaft of the
trimmer with the smooth surface facing you
(Figure
1).
Description
Auxiliary handle
Latch
Brace
Guard
Phillips screw
Wire edge guard
No parts required
Qty.
1
1
Installing auxiliary handle.
1
1
Mounting the guard to the base of the
trimmer.
1
1
Installing the edge guard
Adjust the auxiliary handle, trimmer
–
height, and base position.
1. Auxiliary handle
2. Latch
2.
Slide the brace into the auxiliary handle so that
the brace rests in the groove along the shaft
(Figure
1).
3.
Slide the latch from the left through the handle
and brace as shown and tighten the latch screw
with a Phillips head screwdriver
7
Use
Figure 1
3. Brace
(Figure
g017277
1).