Connections; Power Supply; Projecting Computer Images - Sharp XG-V10XU Operation Manual

Connections

Power Supply

Connecting the Power Cord
Plug the supplied power cord into the AC socket on the side of the projector.

Projecting Computer Images

Connecting the Projector to a Computer
You can connect your projector to a computer for projection of full color computer images.
Connecting to a computer using the standard 15-pin Input
1 3
4
2
1 Connect one end of the supplied RGB cable to the INPUT 1 port on the
projector.
2 Connect the other end to the monitor output port on the computer. Secure the
connectors by tightening the thumb screws.
3 To use the built-in audio system, connect one end of the audio cable (sold
separately) to the AUDIO INPUT 1 terminal on the projector.
4 Connect the other end to the audio output terminal on the computer.
CAUTION
• Before connecting, be sure to turn both the projector and the computer off. After making
all connections, turn the projector on first. The computer should always be turned on
last.
• Please read the computer's operation manual carefully before making connections.
• Refer to page 84 "Computer Compatibility Chart" for a list of computer signals compatible
with the projector. Use with computer signals other than those listed may cause some of
the functions not to work.
• A 3.5 mm stereo minijack to stereo RCA audio cable adaptor may be necessary.
When connecting this projector to a computer, select "RGB" for "Signal Type"
on the GUI menu. (See page 45.)
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact
your nearest Authorized Sharp Industrial LCD Products Dealer or Service Center.
• AUDIO INPUT 1 can be used to input audio corresponding to the INPUT 1.
Power cord
QACCU5013CEZZ
RGB cable
QCNW-5304CEZZ
E-14