Toro Sand Pro 3040 Operator's Manual page 3

6. Secure the right side assembly with a bolt (3/4 x 3-1/2
inches) and a locknut (3/4 inch), torqued to 163 to 217
N-m (120 to 160 ft-lb); refer to
Note: Ensure that the side assemblies pivot freely.
Slightly loosen the nuts and bolts if necessary. Ensure
that the carriage bolts do not contact each other
throughout the range of motion.
3
Installing the Lift Arm to the
QAS Assembly
Parts needed for this procedure:
1 Pivot bar
3 Cotter pin
Procedure
1. Align the holes in the lift arm with the holes in the
QAS assembly (Figure
1. Lift arm
2. Insert the pivot bar through the holes
Figure 3.
4).
Figure 4
2. QAS assembly
(Figure
1. Pivot bar
2. Flange-head bolt
3. Align the hole in the retainer plate with hole in the lift
arm, and install the flange-head bolt and the flange
nut (Figure
4. Install a cotter pin in each of the 3 holes in the pivot
bar (Figure
Note: Ensure that the holes in the pivot bar are
positioned as shown in
1. Pivot bar
5).
5. Bend the ends of the cotter pins to secure the pin in
position.
3
Figure 5
3. Flange nut
5).
6).
Figure 6.
Figure 6
2. Cotter pins