Toro Sand Pro 3040 Operator's Manual page 2

1
Adjusting the Tire Pressure
No Parts Required
Procedure
For the rake to work properly, it is important
for the machine to have the correct tire pressure.
(Figure 1).
To get the most accurate reading, check the tire pressure
when the tires are cold.
•
Treaded tires: 70 kPa (10 psi)
Note: If additional traction is required for blade
operation, reduce the pressure to 55 kPa (8 psi).
•
Smooth tires: 55 to 70 kPa (8 to 10 psi)
2
Installing the Side Assemblies
to the Center Assembly
Parts needed for this procedure:
2 Spacer
2 Bolt (3/4 x 3-1/2 inches)
2 Locknut (3/4 inch)
Procedure
1. Position the assemblies so that the top plate of the
center assembly faces forward and the top plate of each
side assembly faces backward
Figure 1
(Figure 2)
1. Top plate facing forward
(center assembly)
2. Insert a spacer into the pivot hole of each side assembly
(Figure 3).
Left side assembly shown installed
1. Center assembly
2. Bolt (3/4 x 3-1/2 inches)
3. Spacer
3. Align the pivot hole in the left side assembly to the
pivot hole on the left side of the center assembly.
4. Secure the left side assembly with a bolt (3/4 x 3-1/2
inches) and a locknut (3/4 inch), torqued to 163 to 217
N-m (120 to 160 ft-lb); refer to
5. Align the pivot hole in the right side assembly to the
pivot hole on the right side of the center assembly.
2
Figure 2
2. Top plate facing backward
(side assembly)
Figure 3
4. Right side assembly
5. Nut (3/4 inch)
Figure 3.