Installation; About This Chapter; Connect Mu736 To Board - Huawei MU736 Hardware Manual

Hide thumbs Also See for MU736:

Table of Contents

HUAWEI MU736 HSPA+ M.2 Module

Hardware Guide

This chapter describes the assembly of MU736, including:



Figure 7-1 Install MU736

It refers to M.2 specification.

The module will need a mechanical retention at the end of the board. The module

specifies a 5.5 mm Dia. keep out zone at the end for attaching a screw.

The module Stand-off and mounting screw also serve as part of the module Electrical

Ground path. The Stand-off should be connected directly to the ground plane on the

platform. So that when the module is mounted and the mounting screw is screwed on

to hold the module in place, this will make the electrical ground connection from the

module to the platform ground plane.

The stand-off must provide a Thermal Ground Path. The design requirements for

thermal are a material with a minimum conductivity of 50 watts per meter Kelvin and

surface area of 22 Sq mm.

Issue 05 (2014-01-14)

Connect MU736 to Board

Antenna Plug

Huawei Proprietary and Confidential

Installation

Table of Contents