Temperature Rise Completion Range Setting (Buffer Memory Address: A7 H ); Temperature Rise Completion Soak Time Setting (Buffer Memory Address: A8 H ); Pid Continuation Flag (Buffer Memory Address: A9 H ); Heater Disconnection Compensation Function Selection (Buffer Memory Address: Aa H ) - Mitsubishi Electric MELSEC Q Series User Manual

Hide thumbs Also See for MELSEC Q Series:
Table of Contents

Advertisement

3 SPECIFICATIONS
3.5.39 Temperature rise completion range setting (buffer memory address: A7
3.5.40 Temperature rise completion soak time setting (buffer memory address: A8
3.5.41 PID continuation flag (buffer memory address: A9
3.5.42 Heater disconnection compensation function selection (buffer memory address: AA
3.5.43 Transistor output monitor ON delay time setting (buffer memory address: AF
3 - 57
Downloaded from
ManualsNet.com
(1) Sets the temperature rise/fall values, at which a temperature rise will be judged as
completed, relative to the set value.
Temperature rise
completion range (+)
Set value (SV)
Temperature rise
completion range (-)
(2) The setting range is 1 to 10°C.
(1) Sets a delay from when a temperature rise is completed until the temperature rise
completion judgment flag is turned on (1).
(2) The setting range is 0 to 3600 (min).
(1) Sets the operation mode to be entered when Operation mode command (Yn1)
turns from on to off.
• 0: Stop (default)
• 1: Continue
(2) Refer to Section 3.2.13 for the control status governed by on/off of the PID
continuation flag.
(1) Available only for the Q64TCTTBW and Q64TCRTBW.
(2) Sets whether the heater disconnection compensation function (refer to Section
3.2.7) is used or not.
• 0: Heater disconnection compensation function is not used (default)
• 1: Heater disconnection compensation function is used
(1) Make this setting to delay the timing when the transistor output flag (buffer
memory address: 15
Set this when performing heater disconnection detection by using the input
module.
(2) The setting range is 0 and 1 to 50 (10 to 500ms).
When the setting is 0, the transistor output flag (buffer memory address: 15
18
.b8) does not turn on (1).
H
search engine
)
H
to 18
.b8) turns on.
H
H
MELSEC-Q
)
H
Temperature rise
judgment range
)
H
)
H
)
H
to
H
3 - 57

Advertisement

Table of Contents
loading

This manual is also suitable for:

Q64tcttQ64tcttbwQ64tcrtQ64tcrtbw

Table of Contents