Setting Up The Appliance - Silvercrest SMK 41 A2 Operating Instructions Manual

 Place the refrigerator on its back.
 Unscrew the lower hinge (4) and then unscrew the adjustable foot (see Fig. F).
 Remove the screws from the side housing on the left-hand side and place them on the
opposite side.
 Place the two white washers and the locking washer from the lower hinge safely to one
side. They will be required when reinstalling the door.
 Use a wrench (width across of 10 mm) to unscrew the pins on the lower hinge and
when doing so hold in place with a flat-head screwdriver to remove the pins (see
Fig. G).
 Turn over the hinge and reinsert the pins and locking washer.
 Screw the lower hinge on the left-hand side again. Screw in the adjustable foot (5) on
the right-hand side (see Fig. H).
 Stand the appliance upright again. While doing so, hold the appliance door quite
firmly in place.
 Before screwing the upper hinge back on, ensure that the door closes flush with the
appliance housing horizontally and vertically so that all seals close.
 Then put the upper hinge (10) back in place and screw on the hinge with the three
screws. Use a wrench to tighten the screws (see Fig. I).
 Then place the hinge cover and screw covers back into position (see Fig. J).
Please note: The door seal adapts to the new door hinge after a few hours.
If tilted to an angle of more than 40° during transport or when changing the
door fittings, wait 4 hours before connecting it to the mains and switching it on
to enable the refrigerant circuit to settle.

9.2. Setting up the appliance

 Place the appliance in an appropriate location (see also section "3.3.1. Location" on
page 44).
 Ensure that the appliance is level, compensate for any unevenness in the floor by
screwing in the screw feet.
 Level the refrigerator with a spirit level.
To fully open the door, the room dimensions stated in the following figures must be
available.
54 - English