Factory Adj Mode - Pioneer PRO-730HDI Service Manual

1

7.6 FACTORY ADJ MODE

A
Factory Adjustment Mode
Select 1st FACTORY ADJ Mode
Start
POWER
B
" ON "
• To enter FACTORY mode, use the key(s) on the remote control unit or main unit. To release FACTORY mode, use the key(s) of
the remote control unit or the main unit, or turn the power off. If the unit remains in FACTORY mode without any operation for 8
minutes, it will be automatically released.
• In FACTORY mode, data for the picture and audio qualities are standard, and the FLESH TONE setting is always off.
• When the unit enters FACTORY mode, settings such as audio muting, MENU, and SPLIT (two split-screens) are released.
C
• The Convergence data which user adjusted are within the FACTORY mode. Clear the convergence data by releasing the
FACTORY mode after it is further within the MANUAL CONVER mode or OFFSET CONVER mode.
• When the unit exits FACTORY mode, the TV/CATV mode becomes AIR (settings of ANT and CH are those last stored in
memory).
• CONVER. OSD (cross hatch) can be turned on and off cyclically by using the YELLOW key only during CONVER mode
(MANUAL, AUTO, OFFSET adjustments).
(Default: The cross hatch is on only in CONVER. mode.)
1
INPUT OFFSET mode
D
Telop : White
(MUTING)
2
PICTURE OFFSET
mode
Telop : White
E
(MUTING)
3
COLOR TEMP
OFFSET mode
Telop : White
F
96
1
2
Selecting the mode for adjustment operations.
Front panel
INPUT1
position
Press the
switch with
thin rod.
(MUTING)
RANGE CHECK mode
(TV/SAT/DVD MENU)
Telop : Red
(MUTING)
SIGNAL ADJ mode
Telop : White
(MUTING)
(MUTING) CONVER ADJ mode
Telop : White
PRO-730HDI
2
3
Start
Start adjusting
1st FAC
Select 1st FACTORY ADJ mode, then adjust.
Normal
picture
Cyclically
2nd FAC- 1st FAC-
TORY ADJ
TORY ADJ
mode mode
picture
picture
SERVICE mode
(SPLIT)
Telop : White
(SPLIT)
PureCinema mode
Telop : White
(RETURN)
5
(MUTING)
HDMI Information mode
HDMI Control set mode
Telop : White
4
3
4
The 2nd FACTORY
ADJ mode is not used
in the adjustment.
6
7
8
4