To Charge The Battery Pack - Toshiba B-EP800-CHG6-QM-R Owner's Manual

To Charge the Battery Pack

1. The B-EP800-CHG6-QM-R battery charger is designed and manufactured for use with specified lithium-ion
battery packs. The battery used in this device may present a risk of fire or chemical burn if mistreated. Do not
disassemble, heat above +50degC, or incinerate. Replace battery with specified type only. There is a risk of fire or
explosion if the battery is replaced by an incorrect type.
Available
B-EP802-BT-QM-R
Battery Pack
2. Dispose of used battery promptly. Keep away from children. Do not disassemble and do not dispose of in fire.
3. Use only the supplied AC adapter (Model: FSP150-ABAN3) for powering this battery charger.
Please use the following procedure to charge a battery pack. This battery charger can charge six
battery packs at the same time with B-EP802-BT-QM-R, B-EP804-BT-QM-R, B-FP803-BT-QM-R
and the B-FP803-BTH-QM-R mixed.
1. Fit the partition into the slot. The orientation of the partition differs depending on the battery
pack size to be charged.
When charging
B-EP802-BT-QM-R,
B-FP803-BT-QM-R or
B-FP803-BTH-QM-R
battery pack
NOTE:
 Fit the partition in the correct position and orientation and make sure the tabs are fit into the
holes.
 Be careful not to lose the partition.
 Care must be taken not to mistake the orientation, as the partition cannot be removed once it
is fitted.
2. Connect the AC adapter to the battery
charger.
3. Connect the power cord to the AC adapter.
4. Connect the power cord to an AC outlet.
WARNING
B-EP804-BT-QM-R B-FP803-BT-QM-R
Tab
Tab
Battery Charger
4
B-FP803-BTH-QM-R
When charging
B-EP804-BT-QM-R
battery pack
AC Outlet
Power Cord
AC Adapter