Self Print Test And Dump Mode - Toshiba B-EV4T SERIES Owner's Manual

2. PRINTER SETUP
2.9.2 Self Print Test and
Dump Mode
NOTE:
The following commands should
not affect the test print issue.
D, AX, XS, Z2;1, Z2;2 (without
AY)
2.9 Media Sensor Calibration, Self Print Test, and Dump Mode Utilities
1. Turn off the printer power and install a media roll on the printer.
2. Press the [FEED] Button while turning on the printer. The Indicator
Lamp will light up in the following order:
Green (Flashing) → Red (Flashing) → Orange (Flashing) →
Orange → RED → Green
3. Release the [FEED] Button when the Indicator Lamp lights up in
green.
4. The printer automatically performs a self print test, and then enters the
Dump Mode.
5. To start the Online operation, turn the printer off, then on again.
PRINTER INFO.
PROGRAM VERSION
TONE ADJUST
FEED ADJUST
CUT POSITION ADJUST
BACKFEED ADJUST
PARAMETER
X-COORDINATE ADJUST
SENSOR SELECTION
SENSOR ADJ. VALUE
PRINT SPEED
FLASH ROM
SDRAM
USER MEMORY
TTF AREA
EXT CHAR AREA
BASIC AREA
PC SAVE AREA
INFORMATION
TOTAL FEED
TOTAL PRINT
TOTAL CUT
IP ADDRESS
SUBNET MASK
GATEWAY
MAC ADDRESS
DHCP
DHCP CLIENT ID
SOCKET COMM.
SOCKET COMM. PORT
E2-18
Print test label sample
VX.XX XXXX
+XX
+XX.Xmm
+XX.Xmm
+XX.Xmm
[ PC-850 ] [ 0 ]
[ 9600 ] [ 8 ] [ 1 ] [ NONE ] [ 2 ]
[ ON ] [ AUTO ] [ FEED ] [ B0 ]
+XX.Xmm
TRANSMISSIVE
TRANSMISSIVE [XX] REFLECTIVE [XX]
5 IPS
4 MB
8 MB
[ X KB][ 0 KB]
[ 0 KB][ 0 KB]
[ 0 KB][ 0 KB]
[ 0 KB][ 0 KB]
[ X KB][ 0 KB]
0.00 km
0.00 km
0
192.168.10.20
255.255.255.0
0.0.0.0
XX-XX-XX-XX-XX
Disabled
FFFFFFFFFFFFFFFFFFFF
FFFFFFFFFFFF
Enabled
08000
ENGLISH VERSION EO1-33087