Voice First/Tone First; Answer A Voice Call Handsfree - NEC UNIVERGE SV9300 Series User Manual

VOICE FIRST/TONE FIRST

This feature allows incoming calls to your terminal to either ring
or go to voice announcement.
The feature access code/feature key is set by
system data setting at initial installation. For
details, please contact the system administrator.
TO SET VOICE FIRST/TONE FIRST
MODE
1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red.
2.
Dial Voice First/Tone First access code or press
Voice First/Tone First feature key.
LCD shows current mode.
You will receive a feature dial tone.
3.
Dial any single digit ( "0" – "9" ).
Voice First mode is switched to Tone First mode (or
vice versa).
You will receive a feature set tone.
4.
Press Speaker key.
Speaker key lamp goes off.
5.
The called party can reply.
WHEN A CALLED TERMINAL HAS
BEEN SET TO VOICE FIRST
1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red.
Line key lamp lights green.
2.
Dial extension number.
Wait for voice page alert tone.
3.
Speak to the called party.
4.
Dial "1 " .
The called party's extension will ring.
FEATURE OPERATION
WHEN A CALLED TERMINAL HAS
BEEN SET TO TONE FIRST
1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red.
Line key lamp lights green.
2.
Dial extension number.
The called party's extension will ring.
3.
Dial "1 ".
Wait for voice page alert tone.
4.
Start conversation with called party.
5.
The called party can reply.
ANSWER A VOICE CALL
HANDSFREE
This feature allows the terminal user to answer a Voice Call
without lifting the handset.
1.
You will receive an incoming Voice Call.
2.
Press Mic Key.
Mic key lamp lights red.
3.
Respond to call handsfree.
62