Voice First/Tone First - NEC UNIVERGE SV9300 User Manual

The feature key is set by system data
setting at initial installation. For details,
please contact the system
administrator.
TO DISPLAY CALLING
PARTY INFORMATION
1.
Press CID Call Display feature key.
Line key lamp lights red. →
Calling Party information is displayed.
R-TONE MIC
TO REDISPLAY CALLING
PARTY INFORMATION
1.
While on a call press CID Call
Display feature key to recall the
Calling Party Information.
Calling Party information is displayed.

VOICE FIRST/TONE FIRST

This feature allows incoming calls to your
terminal to either ring or go to voice
announcement.
The feature access code/feature key is
set by system data setting at initial
installation. For details, please contact
the system administrator.
TO SET VOICE FIRST/TONE
FIRST MODE
1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2.
Dial Voice First/Tone First access
code or press Voice First/Tone First
201
JAMES SMITH
feature key.
LCD shows current mode.
You will receive a feature dial tone.
VOICE
11:00 AM SUN 1 JUN 2014
Recall
3.
Dial any single digit (
Voice First mode is switched to Tone First
mode (or vice versa).
You will receive a feature set tone.
TONE
11:00 AM SUN 1 JUN 2014
Recall
4.
Press Speaker key.
Speaker key lamp goes off. →
5.
The called party can reply.
WHEN A CALLED TERMINAL
HAS BEEN SET TO VOICE
FIRST
1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
Line key lamp lights green. →
2.
Dial extension number.
Wait for voice page alert tone.
VOICE CALL
11:00 AM SUN 1 JUN 2014
R-TONE
3.
Speak to the called party.
84
FEATURE OPERATION
PICK >>>>
- ).
PICK >>>>
200
MIC