NEC UNIVERGE SV9300 User Manual page 84

1.
The called party extension is busy
or no answer.
You will receive a busy tone.
Line key lamp lights green. →
BUSY
11:00 AM SUN 1 JUN 2014
CB CW
2.
Press Soft key (CB) or Call Back
feature key.
You will receive a service set tone.
SET
11:00 AM SUN 1 JUN 2014
3.
Replace the handset.
Wait Call Back.
Line key lamp goes off. →
WHEN THE BUSY TERMINAL
BECOMES IDLE
1.
The terminal which has set Call
Back is alerted by ring.
When busy terminal becomes idle or the
terminal that did not answer initiates or
answers a call or accesses a feature and
then becomes idle, the setting terminal is
alerted by ring.
Call Indicator Lamp flashes.
Line key lamp flashes green. →
CALL BACK
11:00 AM SUN 1 JUN 2014
MIC DIR
2.
Lift the handset.
The extension number that was busy/no
answer is automatically dialed.
Line key lamp lights green. →
201
>>>>
201
201
HIST. >>>>
76
FEATURE OPERATION
CALL BACK
11:00 AM SUN 1 JUN 2014
Recall VOICE
TO CANCEL
This feature is available only for the
terminal that is set by system data
setting at initial installation. This feature
cannot be canceled by Soft key.
1.
While the terminal is set Call Back
feature,
Call Back feature key lamp lights red. →
2.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
Line key lamp lights green. →
200
11:00 AM SUN 1 JUN 2014
Recall PICK
3.
Press Call Back feature key.
You will receive a service set tone.
Call Back feature key lamp goes off. →
CANCEL
11:00 AM SUN 1 JUN 2014
4.
Press Speaker key.
Speaker key lamp goes off. →
Line key lamp goes off. →
201
CB >>>>
>>>>