Trunk Queuing - Outgoing - NEC UNIVERGE SV9300 User Manual

Up to three Save and Repeat feature
keys can be assigned per terminal.
TO SET SAVE AND REPEAT
1.
Dial the desired number and press
Soft key (S&R) or Save and Repeat
feature key.
HOW TO DIAL BY SAVE AND
REPEAT
1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
Line key lamp lights green. →
11:00 AM SUN 1 JUN 2014
Recall PICK
2.
Save and Repeat feature key.
The terminal automatically redials the
programmed number.
Example: "201" is programmed number.
11:00 AM SUN 1 JUN 2014
Recall VOICE
3.
Lift the handset to start a
conversation.
Speaker key lamp goes off. →
11:00 AM SUN 1 JUN 2014
MIC Mute
Redialing the same number is possible
until new number is registered by this
feature.
200
>>>>
201
CB >>>>
201
TRUNK QUEUING -
OUTGOING
This feature allows a terminal user, upon
encountering a busy signal on a trunk, to set a
call and enter a first-in, first-out queue. As soon
as an outgoing trunk becomes available,
terminals in the queue will be called back on a
first-in, first-out basis.
This feature is set by Soft key or feature
key. The feature key is set by system
data setting at initial installation. For
details, please contact the system
administrator.
TO SET TRUNK QUEUING –
OUTGOING
This feature is available only for the
terminal that is set by system data
setting at initial installation.
1.
Press Speaker key and dial the
outgoing access code.
Speaker key lamp lights red. →
Line key lamp lights red. →
The lines are all busy status.
You will receive a busy tone.
BUSY
11:00 AM SUN 1 JUN 2014
CB
2.
Press Soft key (CB) or Trunk
Queuing - Outgoing feature key.
You will receive a service set tone.
Outgoing feature key lamp lights red. →
74
FEATURE OPERATION
26-255XX