NEC UNIVERGE SV9300 User Manual page 18

ATTACHING FACEPLATE AND DESI PRINTER SHEET
1.
After replacing the DESI Printer Sheet on the terminal, attach the Faceplate.
2.
At each corner, press the locking pin back into place.
(1) Line Key Panel
(2) Center Bar
(3) Face Plate
(4) DESI Printer Sheet
Please attach the Faceplate securely. If not, the terminal will not operate properly because a
key is possibly being pushed by the Faceplate.
ADJUSTING ANGLE OF TILT LEGS
The height can be adjusted by moving the legs attached to the bottom of the terminal.
(1) First Position
(2) Second Position
(3) Third Position
(4) Forth Position
RAISING TILT LEGS
1.
Turn the terminal over (key side down).
2.
Raise Tilt Legs to desired height.
10
INTRODUCTION