NEC UNIVERGE SV9300 User Manual page 132

After starting-up the terminal, Bluetooth function is activated automatically.
After the Bluetooth function is started, the smart device that has been connected last is
connected through Bluetooth to the terminal.
DISABLE BLUETOOTH FUNCTION
1.
During the Connect key lamp lights red, long-press the Connect key more than 3
seconds.
Connect key lamp goes off and Bluetooth function will be disabled. →
2.
It is not possible to disable the Bluetooth function when the terminal and smart device is in
processing of pairing connection.
CONNECT WITH SMART DEVICE
The terminal can be connected with smart device which has completed pairing, automatically or
manually. Only the smart device that has been connected last can be connected through Bluetooth to
the terminal.
AUTOMATIC CONNECTION
Confirm the Bluetooth function is on. (Connect key lamp lights red.) →
1.
2.
Place the smart device that has been connected last through Bluetooth near the
terminal. (Effective range of Bluetooth radio interface is within 10 meter from the
terminal approximately.)
3.
The terminal is connected to the smart device through Bluetooth automatically.
MANUAL CONNECTION
Confirm the Bluetooth function is on. (Connect key lamp lights red.) →
1.
2.
Press Connect Key. (Less than 3 seconds)
3.
The terminal is connected to the smart device through Bluetooth.
SWITCH TERMINAL'S HANDSET TO SMART DEVICE
When you converse with caller using terminal handset, you can switch to the smart device and continue
the conversation without disconnecting the call.
1.
When you are in conversation with caller through mobile phone network, press
Connect key. (Less than 2.5 seconds)
2.
Converse with caller using smart device.
If you press Connect key once again, you can return to the terminal handset and continue
conversation.
APPENDIX D PAIRING WITH SMART DEVICE
124