Call Back - NEC UNIVERGE SV9300 User Manual

3.
Press Speaker key.
Speaker key lamp goes off. →
Wait until the outgoing line is available.
SET
11:00 AM SUN 1 JUN 2014
WHEN TRUNK IS
AVAILABLE
1.
Ringing of external incoming call is
heard.
Call Indicator Lamp flashes red.
Line key lamp flashes green. →

CALL BACK

11:00 AM SUN 1 JUN 2014
Recall PICK
2.
Lift the handset or press Speaker
key.
Outgoing feature key lamp goes off. →
Call Indicator Lamp goes off.
Line key lamp lights green. →
3.
Dial the desired number.
81XXXXXXXXXX
11:00 AM SUN 1 JUN 2014
Recall VOICE
TO CANCEL
This feature is available only for the
terminal that is set by system data
setting at initial installation. This feature
cannot be canceled by Soft key.
1.
Lift the handset.
26-255XX
26-255XX
>>>>
CB >>>>
75
FEATURE OPERATION
Line key lamp lights red. →
200
11:00 AM SUN 1 JUN 2014
Recall PICK
2.
Press Trunk Queuing – Outgoing
feature key.
You will receive a service set tone.
Trunk Queuing – Outgoing feature is
cancelled.
Outgoing feature key lamp goes off. →
CANCEL
11:00 AM SUN 1 JUN 2014
3.
Replace the handset.
Line key lamp goes off. →
CALL BACK
This feature allows a calling party to set an
automatic Call Back when a busy or no answer
condition is encountered. When the busy
terminal becomes idle, the terminal that set the
Call Back will be called.
This feature is set by Soft key or feature
key. The feature key is set by system
data setting at initial installation. For
details, please contact the system
administrator.
TO SET CALL BACK
This feature is available only for the
terminal that is set by system data
setting at initial installation.
>>>>