Call Back - NEC Univerge SV9300 Series User Manual

CALL BACK

This feature allows a calling party to set an
automatic Call Back when a busy or no answer
condition is encountered. When the busy terminal
becomes idle, the terminal that set the Call Back
will be called.
This feature is set by Soft key or feature key.
The feature key is set by system data setting
at initial installation. For details, please
contact the system administrator.
TO SET CALL BACK
This feature is available only for the terminal
that is set by system data setting at initial
installation.
1. The called party extension is busy or
no answer.
You will receive a busy tone.
Line key lamp lights green. →
BUSY
4:26 PM MON 11 MAY 2015
CB CW
2. Press Soft key (CB) or Call Back
feature key.
You will receive a service set tone.
SET
4:26 PM MON 11 MAY 2015
3. Replace the handset.
Wait Call Back.
Line key lamp goes off. →
WHEN THE BUSY TERMINAL
BECOMES IDLE
201
>>>>
TO CANCEL
201
71
FEATURE OPERATION
1. The terminal which has set Call Back
is alerted by ring.
When busy terminal becomes idle or the
terminal that did not answer initiates or
answers a call or accesses a feature and then
becomes idle, the setting terminal is alerted
by ring.
Call Indicator Lamp flashes.
Line key lamp flashes green. →
CALL BACK
4:26 PM MON 11 MAY 2015
MIC DIR
2. Lift the handset.
The extension number that was busy/no
answer is automatically dialed.
Line key lamp lights green. →
CALL BACK
4:26 PM MON 11 MAY 2015
Recall VOICE
This feature is available only for the terminal
that is set by system data setting at initial
installation. This feature cannot be canceled
by Soft key.
1. While the terminal is set Call Back
feature,
Call Back feature key lamp lights red. →
2. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
Line key lamp lights green. →
4:26 PM MON 11 MAY 2015
Recall PICK
201
HIST. >>>>
201
CB >>>>
200
>>>>