To Backup Or Restore The Setting Data Of Terminal - NEC Univerge SV9300 Series User Manual

22. Press Soft key (Exit).
The display goes back to the [Download
Menu] screen.
When the downloading process ends in
failure, "Downloading Failed!" is displayed on
the LCD. Check to see the following points
and retry download.
CHECK POINTS
Check whether the down-
load file is placed in the
folder of the server or not.
Check if the file name you
entered is match with that
stored in FTP/TFTP/
HTTPS server.
Check whether IP address/
address (URI) of FTP/
TFTP/HTTPS server is
correct or not.
Check whether the power
to FTP/TFTP/HTTPS serv-
er and network equipment
is ON or not.
Check whether the LAN
cable is connected secure-
ly.
If the retry of downloading fails many times,
the terminal may be in failure. For details,
please contact the system administrator.
Other than above conditions, if "Download
Failed!" or "Upload Failed!" is displayed,
please contact the system administrator.
ACTIONS
Place the download
file in the specified
folder of the server.
Enter the correct file
name which is stor-
ed in FTP/TFTP/
HTTPS server.
Set the proper IP
address/address
(URI) of FTP/TFTP/
HTTPS server.
Turn on the power.
Reconnect the ca-
ble securely.
45
TO BACKUP OR RESTORE
THE SETTING DATA OF
TERMINAL
This section explains how to make a backup of the
setting data which has been entered in the terminal
to FTP/TFTP/HTTPS server. The data in FTP/
TFTP/HTTPS server can be also restored to the
terminal.
When downloading these files, the terminal
needs to be connected to the network that
has FTP, TFTP or HTTPS server.
For details about FTP/TFTP/HTTPS service,
please contact the system administrator.
HTTPS protocol is supported for terminal
firmware 3.1.0.0 or later.
For details of terminal firmware version,
please contact the system administrator.
TO BACKUP THE SETTING
DATA OF TERMINAL
1. Press
Menu
Menu Screen.
2. Select "Setting".
Highlight an item by using
.
3. Select " Data Backup/Restore".
Select one of the following operations.
• Highlight an item by using
, or Soft key (OK).
• Press .
Data Backup/Restore
3
↑
TERMINAL SETUP
key to display the
, and press
, and press
Back OK